Differences

This shows you the differences between two versions of the page.

--- how_to_crack_wep_with_no_clients [2009/09/26 14:34] – Fixed typos darkaudax
+++ how_to_crack_wep_with_no_clients [2010/08/29 19:44] – Fixed channel/frequency graph link mister_x
@@ Line 103: / Line 103: @@
 In the response above, you can see that ath0 is in monitor mode, on the 2.452GHz frequency which is channel 9 and the Access Point shows the MAC address of your wireless card.  So everything is good.   It is important to confirm all this information prior to proceeding, otherwise the following steps will not work properly. (Note: If you are using a driver other than madwifi, then the Access Point field will be either invisible or show something other than your card's MAC address. This is normal.)
-To match the frequency to the channel, check out:
+To match the frequency to the channel, check out: http://www.cisco.com/en/US/docs/wireless/technology/channel/deployment/guide/Channel.html#wp134132 .  This will give you the frequency for each channel.
-http://www.rflinx.com/help/calculations/#2.4ghz_wifi_channels then select the "Wifi Channel Selection and Channel Overlap" tab.  This will give you the frequency for each channel.
 === Troubleshooting Tips ===