User Tools

Site Tools


cracking_wpa

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision
Previous revision
Last revisionBoth sides next revision
cracking_wpa [2010/03/07 16:10] – forgot to update the version and date mister_xcracking_wpa [2018/03/11 20:10] – Removed link to trac mister_x
Line 21: Line 21:
  
 It is recommended that you experiment with your home wireless access point to get familiar with these ideas and techniques. If you do not own a particular access point, please remember to get permission from the owner prior to playing with it. It is recommended that you experiment with your home wireless access point to get familiar with these ideas and techniques. If you do not own a particular access point, please remember to get permission from the owner prior to playing with it.
- 
-I would like to acknowledge and thank the [[http://trac.aircrack-ng.org/wiki/Team|Aircrack-ng team]] for producing such a great robust tool.  
  
 Please send me any constructive feedback, positive or negative. Additional troubleshooting ideas and tips are especially welcome. Please send me any constructive feedback, positive or negative. Additional troubleshooting ideas and tips are especially welcome.
Line 147: Line 145:
 In the response above, you can see that ath0 is in monitor mode, on the 2.452GHz frequency which is channel 9 and the Access Point shows the MAC address of your wireless card.  Only the madwifi-ng drivers show the card MAC address in the AP field, other drivers do not.  So everything is good.   It is important to confirm all this information prior to proceeding, otherwise the following steps will not work properly. In the response above, you can see that ath0 is in monitor mode, on the 2.452GHz frequency which is channel 9 and the Access Point shows the MAC address of your wireless card.  Only the madwifi-ng drivers show the card MAC address in the AP field, other drivers do not.  So everything is good.   It is important to confirm all this information prior to proceeding, otherwise the following steps will not work properly.
  
-To match the frequency to the channel, check out: +To match the frequency to the channel, check out: http://www.cisco.com/en/US/docs/wireless/technology/channel/deployment/guide/Channel.html#wp134132 .  This will give you the frequency for each channel.
-http://www.rflinx.com/help/calculations/#2.4ghz_wifi_channels then select the "Wifi Channel Selection and Channel Overlap" tab.  This will give you the frequency for each channel.+
  
 === Step 1b - Setting up mac80211 drivers === === Step 1b - Setting up mac80211 drivers ===
cracking_wpa.txt · Last modified: 2022/01/02 21:34 by mister_x