airmon-ng
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
airmon-ng [2015/08/23 23:57] – [Typical Uses] wording mister_x | airmon-ng [2019/05/01 22:15] – [Madwifi-ng driver monitor mode] Updated indentation mister_x | ||
---|---|---|---|
Line 111: | Line 111: | ||
If you want to use ath0 (which is already used): | If you want to use ath0 (which is already used): | ||
- | airmon-ng stop ath0 | + | |
And the system will respond: | And the system will respond: | ||
Line 131: | Line 131: | ||
You can see ath0 is gone. | You can see ath0 is gone. | ||
- | To start ath0 in monitor mode: airmon-ng start wifi0 | + | To put wifi0 in monitor mode: |
+ | |||
+ | | ||
System responds: | System responds: | ||
Line 165: | Line 167: | ||
You can set the channel number by adding it to the end: airmon-ng start wifi0 9 | You can set the channel number by adding it to the end: airmon-ng start wifi0 9 | ||
- | |||
- | |||
- | ==== mac80211 drivers monitor mode ==== | ||
- | |||
- | See [[install_drivers# | ||
- | |||
- | When using the mac80211 version of a driver, the use of airmon-ng and the aircrack-ng tools are slightly different. | ||
- | |||
- | Running: | ||
- | |||
- | | ||
- | |||
- | Gives something like: | ||
- | |||
- | | ||
- | |||
- | | ||
- | (monitor mode enabled on mon0) | ||
- | |||
- | Notice that it created " | ||
- | |||
- | To remove monitor mode enter: | ||
- | |||
- | | ||
airmon-ng.txt · Last modified: 2022/02/09 00:34 by mister_x