User Tools

Site Tools


cracking_wpa

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Last revision Both sides next revision
cracking_wpa [2010/03/07 16:10]
mister_x forgot to update the version and date
cracking_wpa [2010/08/29 19:44]
mister_x Fixed channel/frequency graph link
Line 147: Line 147:
 In the response above, you can see that ath0 is in monitor mode, on the 2.452GHz frequency which is channel 9 and the Access Point shows the MAC address of your wireless card.  Only the madwifi-ng drivers show the card MAC address in the AP field, other drivers do not.  So everything is good.   It is important to confirm all this information prior to proceeding, otherwise the following steps will not work properly. In the response above, you can see that ath0 is in monitor mode, on the 2.452GHz frequency which is channel 9 and the Access Point shows the MAC address of your wireless card.  Only the madwifi-ng drivers show the card MAC address in the AP field, other drivers do not.  So everything is good.   It is important to confirm all this information prior to proceeding, otherwise the following steps will not work properly.
  
-To match the frequency to the channel, check out: +To match the frequency to the channel, check out: http://www.cisco.com/en/US/​docs/​wireless/​technology/​channel/​deployment/​guide/Channel.html#​wp134132 ​.  This will give you the frequency for each channel.
-http://www.rflinx.com/help/calculations/#​2.4ghz_wifi_channels then select the "​Wifi ​Channel ​Selection and Channel Overlap"​ tab.  This will give you the frequency for each channel.+
  
 === Step 1b - Setting up mac80211 drivers === === Step 1b - Setting up mac80211 drivers ===
cracking_wpa.txt · Last modified: 2018/03/11 20:10 by mister_x