User Tools

Site Tools


how_to_crack_wep_with_no_clients

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision
Previous revision
Next revisionBoth sides next revision
how_to_crack_wep_with_no_clients [2009/09/26 14:34] – Fixed typos darkaudaxhow_to_crack_wep_with_no_clients [2010/11/21 09:19] – typos sleek
Line 103: Line 103:
 In the response above, you can see that ath0 is in monitor mode, on the 2.452GHz frequency which is channel 9 and the Access Point shows the MAC address of your wireless card.  So everything is good.   It is important to confirm all this information prior to proceeding, otherwise the following steps will not work properly. (Note: If you are using a driver other than madwifi, then the Access Point field will be either invisible or show something other than your card's MAC address. This is normal.) In the response above, you can see that ath0 is in monitor mode, on the 2.452GHz frequency which is channel 9 and the Access Point shows the MAC address of your wireless card.  So everything is good.   It is important to confirm all this information prior to proceeding, otherwise the following steps will not work properly. (Note: If you are using a driver other than madwifi, then the Access Point field will be either invisible or show something other than your card's MAC address. This is normal.)
  
-To match the frequency to the channel, check out: +To match the frequency to the channel, check out: http://www.cisco.com/en/US/docs/wireless/technology/channel/deployment/guide/Channel.html#wp134132 .  This will give you the frequency for each channel.
-http://www.rflinx.com/help/calculations/#2.4ghz_wifi_channels then select the "Wifi Channel Selection and Channel Overlap" tab.  This will give you the frequency for each channel.+
  
 === Troubleshooting Tips === === Troubleshooting Tips ===
Line 234: Line 233:
 When a packet from the access point arrives, enter "y" to proceed.  You may need to try a few to be successful. When a packet from the access point arrives, enter "y" to proceed.  You may need to try a few to be successful.
  
-When successful, the system reponds:+When successful, the system responds:
  
    Saving chosen packet in replay_src-0203-180328.cap    Saving chosen packet in replay_src-0203-180328.cap
Line 451: Line 450:
         Use this packet ? y         Use this packet ? y
  
-Enter "y" to use this packet.  The system responds by showing how many packets it is injecting and reminds you to start airodumump if it has not already been started:+Enter "y" to use this packet.  The system responds by showing how many packets it is injecting and reminds you to start airodump-ng if it has not already been started:
  
    Saving chosen packet in replay_src-0204-104917.cap    Saving chosen packet in replay_src-0204-104917.cap
how_to_crack_wep_with_no_clients.txt · Last modified: 2018/03/11 20:15 by mister_x