rt2500
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
rt2500 [2007/03/07 18:07] – trampolando | rt2500 [2008/06/28 14:48] – Some changes related to the mac80211 version. netrolller3d | ||
---|---|---|---|
Line 8: | Line 8: | ||
tar -xvzf rt2500-cvs-daily.tar.gz | tar -xvzf rt2500-cvs-daily.tar.gz | ||
cd rt2500-cvs-xxxxxxx/ | cd rt2500-cvs-xxxxxxx/ | ||
- | #xxxxxxxxxx is a number | + | #xxxxxxxxxx is a number |
make && make install | make && make install | ||
modprobe rt2500 | modprobe rt2500 | ||
+ | |||
+ | NOTE: This will download the Enhanced Legacy version of the driver. The Next Generation version (rt2x00, [[mac80211]]-based) has not been tested to work with Aircrack-ng. | ||
Make sure to load the driver with modprobe (not insmod) and to put the card in Monitor mode before bringing the interface up. | Make sure to load the driver with modprobe (not insmod) and to put the card in Monitor mode before bringing the interface up. | ||
+ | You also need the following each time you want to use the device in monitor mode: | ||
+ | |||
+ | | ||
+ | | ||
+ | |||
+ | The forceprism corrects the power being shown as " | ||
+ | |||
+ | |||
+ | |||
+ | |||
+ | ====== When to use this driver? ====== | ||
+ | |||
+ | See this [[http:// | ||
- | FIXME | + | If you have a Ralink chip in an USB device and that chip is a RT2570 or RT73 (RT73 is also known as RT2571 and RT2573), you need the " |
- | This doesn' | + | Using legacy drivers (or ASPj mods) interface name is ra0 for PCI/PCMCIA and rausb0 for USB devices, if you have wlan0 and wmaster0 interfaces, then you are using new rt2x00 driver (rt2x00 |
rt2500.txt · Last modified: 2017/01/09 21:31 by mister_x