User Tools

Site Tools


shared_key

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Last revision Both sides next revision
shared_key [2008/11/08 01:45]
darkaudax fixed typo
shared_key [2010/11/20 23:53]
sleek typo
Line 58: Line 58:
 ==== Solution Overview ==== ==== Solution Overview ====
  
-In order to do a shared key fake authentication,​ you need to have a PRGA (pseudo random ​genration ​algorithm) xor file to feed into it.  We will look at the detailed steps to obtain this in a typical scenario. ​ Then use the PRGA xor file to do a fake authentication.+In order to do a shared key fake authentication,​ you need to have a PRGA (pseudo random ​generation ​algorithm) xor file to feed into it.  We will look at the detailed steps to obtain this in a typical scenario. ​ Then use the PRGA xor file to do a fake authentication.
  
 Here are the basic steps we will be going through: Here are the basic steps we will be going through:
Line 107: Line 107:
 In the response above, you can see that ath0 is in monitor mode, on the 2.452GHz frequency which is channel 9 and the Access Point shows the MAC address of your wireless card.  Only the madwifi-ng drivers show the MAC address of the card in the AP field, other drivers do no.  So everything is good.   It is important to confirm all this information prior to proceeding, otherwise the following steps will not work properly. In the response above, you can see that ath0 is in monitor mode, on the 2.452GHz frequency which is channel 9 and the Access Point shows the MAC address of your wireless card.  Only the madwifi-ng drivers show the MAC address of the card in the AP field, other drivers do no.  So everything is good.   It is important to confirm all this information prior to proceeding, otherwise the following steps will not work properly.
  
-To match the frequency to the channel, check out: +To match the frequency to the channel, check out: http://www.cisco.com/en/US/​docs/​wireless/​technology/​channel/​deployment/​guide/Channel.html#​wp134132 ​.  This will give you the frequency for each channel.
-http://www.rflinx.com/help/calculations/#​2.4ghz_wifi_channels then select the "​Wifi ​Channel ​Selection and Channel Overlap"​ tab.  This will give you the frequency for each channel.+
  
 === Troubleshooting Tips === === Troubleshooting Tips ===
shared_key.txt · Last modified: 2018/03/11 20:19 by mister_x