User Tools

Site Tools


simple_wep_crack

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Last revision Both sides next revision
simple_wep_crack [2010/03/14 22:49]
mister_x it's aireplay-ng, not aireokat-bg :)
simple_wep_crack [2010/08/29 19:41]
mister_x Fixed channel/frequency graph link
Line 117: Line 117:
           Tx excessive retries:​0 ​ Invalid misc:​0 ​  ​Missed beacon:0           Tx excessive retries:​0 ​ Invalid misc:​0 ​  ​Missed beacon:0
  
-In the response above, you can see that ath0 is in monitor mode, on the 2.452GHz frequency which is channel 9 and the Access Point shows the MAC address of your wireless card.  Please note that only the madwifi-ng drivers show the MAC address of your wireless card, the other drivers do not do this.  So everything is good.   ​It is important to confirm all this information prior to proceeding, otherwise the following steps will not work properly.+In the response above, you can see that ath0 is in monitor mode, on the 2.452GHz frequency which is channel 9 and the Access Point shows the MAC address of your wireless card.  Please note that only the madwifi-ng drivers show the MAC address of your wireless card, the other drivers do not do this.  So everything is good. It is important to confirm all this information prior to proceeding, otherwise the following steps will not work properly.
  
 To match the frequency to the channel, check out: To match the frequency to the channel, check out:
-http://www.rflinx.com/help/calculations/#​2.4ghz_wifi_channels then select the "​Wifi ​Channel ​Selection and Channel Overlap"​ tab.  This will give you the frequency for each channel.+http://www.cisco.com/en/US/​docs/​wireless/​technology/​channel/​deployment/​guide/Channel.html#​wp134132 ​.  This will give you the frequency for each channel.
  
  
simple_wep_crack.txt ยท Last modified: 2018/03/11 20:13 by mister_x