faq
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
faq [2019/09/09 00:16] – ath10k_pci 0000:03:00.0: firmware: failed to load ath10k/pre-cal-pci-0000:03:00.0.bin mister_x | faq [2020/02/26 20:47] – [What is the best wireless card to buy ?] updated AWUS036ACM mister_x | ||
---|---|---|---|
Line 9: | Line 9: | ||
* Alfa AWUS036ACH (a/ | * Alfa AWUS036ACH (a/ | ||
- | * Alfa AWUS036ACM (a/ | + | * Alfa AWUS036ACM (a/ |
Runner ups: | Runner ups: | ||
Line 190: | Line 190: | ||
===== How do I change my card's MAC address ? ===== | ===== How do I change my card's MAC address ? ===== | ||
+ | |||
+ | **Note:** It is not necessary to change the MAC address anymore to perform attacks; this can, in some cases, confuse the driver. | ||
Under linux, the following information applies. | Under linux, the following information applies. | ||
Line 633: | Line 635: | ||
The driver doesn' | The driver doesn' | ||
+ | |||
+ | ===== Why does using aircrack-ng with "-p 1" use 2 CPUs ===== | ||
+ | |||
+ | The " | ||
+ | |||
+ | ===== " | ||
+ | |||
+ | Prior to this message, it can be seen that the device connected on a USB port with xhci_hcd, indicating USB 3.0. | ||
+ | |||
+ | This issue happens mostly in virtual machines, when the USB port is set to 3.0. To work around the issue, power off the virtual machine, edit USB settings of the VM and set it to 2.0. | ||
+ | |||
+ | ===== Where can I find airmon-ng on Windows or MacOS? ===== | ||
+ | |||
+ | [[airmon-ng]] is a Linux/ |
faq.txt · Last modified: 2024/01/10 16:40 by mister_x