cracking_wpa
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
cracking_wpa [2010/03/07 16:10] – forgot to update the version and date mister_x | cracking_wpa [2018/03/11 20:10] – Removed link to trac mister_x | ||
---|---|---|---|
Line 21: | Line 21: | ||
It is recommended that you experiment with your home wireless access point to get familiar with these ideas and techniques. If you do not own a particular access point, please remember to get permission from the owner prior to playing with it. | It is recommended that you experiment with your home wireless access point to get familiar with these ideas and techniques. If you do not own a particular access point, please remember to get permission from the owner prior to playing with it. | ||
- | |||
- | I would like to acknowledge and thank the [[http:// | ||
Please send me any constructive feedback, positive or negative. Additional troubleshooting ideas and tips are especially welcome. | Please send me any constructive feedback, positive or negative. Additional troubleshooting ideas and tips are especially welcome. | ||
Line 147: | Line 145: | ||
In the response above, you can see that ath0 is in monitor mode, on the 2.452GHz frequency which is channel 9 and the Access Point shows the MAC address of your wireless card. Only the madwifi-ng drivers show the card MAC address in the AP field, other drivers do not. So everything is good. It is important to confirm all this information prior to proceeding, otherwise the following steps will not work properly. | In the response above, you can see that ath0 is in monitor mode, on the 2.452GHz frequency which is channel 9 and the Access Point shows the MAC address of your wireless card. Only the madwifi-ng drivers show the card MAC address in the AP field, other drivers do not. So everything is good. It is important to confirm all this information prior to proceeding, otherwise the following steps will not work properly. | ||
- | To match the frequency to the channel, check out: | + | To match the frequency to the channel, check out: http://www.cisco.com/en/US/ |
- | http://www.rflinx.com/help/calculations/# | + | |
=== Step 1b - Setting up mac80211 drivers === | === Step 1b - Setting up mac80211 drivers === |
cracking_wpa.txt · Last modified: 2022/01/02 21:34 by mister_x