shared_key
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
shared_key [2008/11/08 01:45] – fixed typo darkaudax | shared_key [2018/03/11 20:19] (current) – Removed link to trac mister_x | ||
---|---|---|---|
Line 17: | Line 17: | ||
It is recommended that you experiment with your home wireless access point to get familiar with these ideas and techniques. If you do not own a particular access point, please remember to get permission from the owner prior to playing with it. | It is recommended that you experiment with your home wireless access point to get familiar with these ideas and techniques. If you do not own a particular access point, please remember to get permission from the owner prior to playing with it. | ||
- | I would like to acknowledge and thank the [[http:// | + | I would like to acknowledge and thank the Aircrack-ng team for producing such a great robust tool. |
Please send me any constructive feedback, positive or negative. Additional troubleshooting ideas and tips are especially welcome. | Please send me any constructive feedback, positive or negative. Additional troubleshooting ideas and tips are especially welcome. | ||
Line 58: | Line 58: | ||
==== Solution Overview ==== | ==== Solution Overview ==== | ||
- | In order to do a shared key fake authentication, | + | In order to do a shared key fake authentication, |
Here are the basic steps we will be going through: | Here are the basic steps we will be going through: | ||
Line 107: | Line 107: | ||
In the response above, you can see that ath0 is in monitor mode, on the 2.452GHz frequency which is channel 9 and the Access Point shows the MAC address of your wireless card. Only the madwifi-ng drivers show the MAC address of the card in the AP field, other drivers do no. So everything is good. It is important to confirm all this information prior to proceeding, otherwise the following steps will not work properly. | In the response above, you can see that ath0 is in monitor mode, on the 2.452GHz frequency which is channel 9 and the Access Point shows the MAC address of your wireless card. Only the madwifi-ng drivers show the MAC address of the card in the AP field, other drivers do no. So everything is good. It is important to confirm all this information prior to proceeding, otherwise the following steps will not work properly. | ||
- | To match the frequency to the channel, check out: | + | To match the frequency to the channel, check out: http://www.cisco.com/en/US/ |
- | http://www.rflinx.com/help/calculations/# | + | |
=== Troubleshooting Tips === | === Troubleshooting Tips === |
shared_key.txt · Last modified: 2018/03/11 20:19 by mister_x