Differences

This shows you the differences between two versions of the page.

--- simple_wep_crack [2010/03/14 22:49]
mister_x it's aireplay-ng, not aireokat-bg :)
+++ simple_wep_crack [2010/08/29 19:41]
mister_x Fixed channel/frequency graph link
@@ Line 117: / Line 117: @@
           Tx excessive retries:0  Invalid misc:0   Missed beacon:0
-In the response above, you can see that ath0 is in monitor mode, on the 2.452GHz frequency which is channel 9 and the Access Point shows the MAC address of your wireless card.  Please note that only the madwifi-ng drivers show the MAC address of your wireless card, the other drivers do not do this.  So everything is good.   It is important to confirm all this information prior to proceeding, otherwise the following steps will not work properly.
+In the response above, you can see that ath0 is in monitor mode, on the 2.452GHz frequency which is channel 9 and the Access Point shows the MAC address of your wireless card.  Please note that only the madwifi-ng drivers show the MAC address of your wireless card, the other drivers do not do this.  So everything is good. It is important to confirm all this information prior to proceeding, otherwise the following steps will not work properly.
 To match the frequency to the channel, check out:
-http://www.rflinx.com/help/calculations/#2.4ghz_wifi_channels then select the "Wifi Channel Selection and Channel Overlap" tab.  This will give you the frequency for each channel.
+http://www.cisco.com/en/US/docs/wireless/technology/channel/deployment/guide/Channel.html#wp134132 .  This will give you the frequency for each channel.

Aircrack-ng

User Tools

Site Tools

Differences

Page Tools