wpa_migration_mode
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Last revision Both sides next revision | ||
|
wpa_migration_mode [2010/08/11 23:12] mister_x cosmetic change |
wpa_migration_mode [2010/08/29 19:43] mister_x Fixed channel/frequency graph link |
||
|---|---|---|---|
| Line 96: | Line 96: | ||
| In the response above, you can see that mon0 is in monitor mode, on the 2.447GHz frequency which is channel 8 and the Access Point shows the MAC address of your wireless card. Please note that only the madwifi-ng drivers show the MAC address of your wireless card, the other drivers do not do this. So everything is good. It is important to confirm all this information prior to proceeding, otherwise the following steps will not work properly. | In the response above, you can see that mon0 is in monitor mode, on the 2.447GHz frequency which is channel 8 and the Access Point shows the MAC address of your wireless card. Please note that only the madwifi-ng drivers show the MAC address of your wireless card, the other drivers do not do this. So everything is good. It is important to confirm all this information prior to proceeding, otherwise the following steps will not work properly. | ||
| - | To match the frequency to the channel, check out: http://www.rflinx.com/help/calculations/# | + | To match the frequency to the channel, check out: http://www.cisco.com/en/US/ |
| ==== Step 2 - Start airodump-ng to capture the IVs ==== | ==== Step 2 - Start airodump-ng to capture the IVs ==== | ||
wpa_migration_mode.txt · Last modified: 2018/03/11 20:19 by mister_x
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
